Operation has been checked. The sound through the amp is fine, with no Noise from poor contact with jack or other. The frets are at their lowest, 65% on the first and third strings at the first and third frets, and 70. 80% on the rest of the strings. The neck has been adjusted to be straight or slightly forward warped. Please note that this. The truss rod was turned about 60° clockwise during the adjustment, but it is quite stiff. Truss rod can be turned left and right, but it requires a lot of force. String height is about 2mm on the 6th string at the 12th fret and 1.5mm on the 1st string. The volume pot, tone pot, condenser, jack, pickguard screws, switch screws, bridge saddle. Screws, escutcheon screws, peg screws, strap pins, and strings have been replaced with new. The knobs are black metal knobs for personal preference. The original hat knob is not there as. It is used separately. The arm is not the original, but I have one on hand that fits just fine, so I will include it here. Please take a good look at the following points of interest. There is a chip on the 6th string side of the nut. It does not reach the groove, so the string will. There are a few scratches on the frets. There is rust on the bridge, escutcheon, pegs, and switch lever. There are dents, scratches, and paint cracks on the body. There is no back panel. The only accessory is the arm, no case is included. International Buyers – Special Attention. Company or when you pick the item up – do not confuse them for. We do not mark merchandise values below value or mark items as. “Gifts” – US and International government regulations prohibit such.